Hot water flow switch FLV-008 1/2" Gas
€59.90
Tax included
Tax may vary according to the country of destination
Hot water flow switch FLV-008
Installation: vertical
Plumbing connection: 1/2" Gas
Electric connection: two 6.3 x 0.8mm faston
Body material: Black PPO Noryl GFN1630V
Input thread: Brass
Output thread: PPO Noryl
.png)
Shipments to the European Union
Click & Collect
View shops
Flow sensor with: 1/2 inch Gas connection, brass body of water-input thread where can be attached a maximum output torque of 35 Nm.
To be installed on heating systems - i.e. pellet and biomasses stoves and gas boilers -, the flow switch purpose is to record the request of hot water and give it the priority if necessary.
Made of sturdy black PPO Noryl GFN1630V plastic - that has been stabilised through hydrolysis - the flow sensor is to be vertically installed, with a maximum slope of 10°; it has a maximum operation pressure of 8 Kg/cm² and a maximum operating temperature of 80°C.
The magnetic float, made of PA6 plastic ferrite, is pushed out of the reed commutation switch's detection field when there is a water request.
14707004
Hot water flow switch FLV-008
Installation: vertical
Plumbing connection: 1/2" Gas
Electric connection: two 6.3 x 0.8mm faston
Body material: Black PPO Noryl GFN1630V
Input thread: Brass
Output thread: PPO Noryl